![]() ![]() When composing MIDI back in the mid 90's, I don't recall any knowledge or adjustment of sampling rate or bit depth. However - when it comes time to finalize and "preserve" my finished tracks, I may bounce them to audio so they won't have to rely on the necessary installed VST's years down the road. ![]() To reiterate, my projects are strictly instrumental MIDI / SoftSynth-driven tracks with no audio / recorded data whatsoever. Thank you, all, for the concise and detailed answers! Note that record bit depth is not used till you record audio (probably the case in your setup with Realtek). But every single bit is around 6dB, which you can have as a "headroom" during recording to get equivalent precision. Real bit depth is around 20bit on good interfaces, extra bits are just noise (if you know SNR or Dynamic Range of your interface, you can estimate meaningful bit depth by dividing this number by 6). #Mediahuman audio converter freezing drivers#Note that 16/24bit are fixed point numbers, audio interfaces always sample into fixed point numbers (even so drivers in some modes can transfer the data as 32bit and some interfaces claim they are 32bit). 32bit engine data will be saved "as is" and in case of 64bit engine, 32bits is still sufficient (extreme and artificial processing is required to produce any difference in sound between 32bit and 64bit files, such processing is never used in real projects).īut record bit depth should be as high as your audio interface support. Normally render bit depth should be 32bit. Obviously the change has no influence on already recorded material, if you have recorded in 16bit, the file will stay 16bit after you change the setting to 24bit.Ĭakewalk internally process in 32bit (floating point) or 64bit (if 64bit engine setting is activated). And it can be different for different settings at the same time. For several reasons, if you always use the same Sample Rate in Cakewalk better set the same in Windows.īit depth of everything can be changed any time. ![]() Also Cakewalk use the audio interface with current project sample rate (only). That is why the setting is called "Default for New Project", that is one time decision at the project creation. So, if your project is already 44.1kHz, you can't change it later. Any project has fixed sample rate and it can't be changed. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |